|
I hate table saws...they are messy and dangerous...
Here are a sequence of pictures of the jig I use... one jig does all the cuts, after each cut , I adjust the fence and move the main assembley to thenext location
First picture is of the bottom lip... second is of my first cut, maybe the most important... third is of the second slope ange ...
Alll holes are fefrenced off of the belly hole, the tail stock is movable to accomodate different sized plugs, the pin hold the plug tight, no clams are needed, which I found to be problematic with the original jig I made.... pre detirmined areas are marked on the blank prior to cutting, these referance the start of each new cut...
|
Threaded Mode