My DIY Duplicator is Finally Done

[WoodyCT]

Originally Posted by LaPala

Nice job. Is the result direct from the carbide bit without sanding?

Can you tell me where and what bit to get and the holder too?

Carbide bit leaves the blank quite fuzzy (as seen on the parts of the blank that are rough looking), but a little 80 grit followed by 120 grit and the blank will be what you see in these pics.

I can put you in touch with the bit/holder supplier.

[LaPala]

Originally Posted by WoodyCT

Carbide bit leaves the blank quite fuzzy (as seen on the parts of the blank that are rough looking), but a little 80 grit followed by 120 grit and the blank will be what you see in these pics.

I can put you in touch with the bit/holder supplier.

Would appreciate that Woody