Quote:
Originally Posted by nightfighter
So how did everyone make out with their machines of choice? Much of the area I had to clear was hardpacked by the wind. It was also higher than the top of the machine's opening. I would plow into it, let the augers undermine it, pull back and hit it again. Often had to knock it down though.
After 3-4 hours, the machine started to stall when the impeller must have been overloaded. At least I that
s what I think. If I disengaged the auger/impeller when it began to struggle, it would return to normal. Also started to hear a clunk when engaging.....I will explore that today. Any thoughts on that?
|
Tighten the cable running from the handle, should be a double threaded screw in line? Topping off the gas helps too, as you found out, as you tilt the machine to eat through high banks.
Given the diversity of the human species, there is no “normal” human genome sequence. We are all mutants.
Threaded Mode