Through drilling process

[Slipknot]

Originally Posted by adson

am I the only one that get a squeal from the drill bit when doing this ?
way too loud, I can stop it with WD40 on the bit but that only lasts for a plug or two...

After you put the bit in, run the tailstock down to the bit and see if they line up. The 2 points must be real close to lining up to each other if you want your holes to line up and meet in the middle.
Squealing seems to happen when the bit wanders and bends.

I wouldn't put oil on the bit, it'll transfer to the wood and effect the painting process possibly.

[numbskull]

I've never drilled a plug on a lathe, seems way too much trouble.
A drill press with a centered bit to drill pilot holes, then connect with a hand drill works for me.....until the bit dulls at least.

[BigFish]

Ditto what George said!