My plug shop is finally finished

[UserRemoved]

Too clean

You need ground wires on that dust collection hose. Can't tell from the pics but it doesn't look like there's wires around the fittings...You are going to have a problem with that collection bag when it gets part full. Just from experience with that unit..

[eskimo]

Holy smokes! Wish my bedroom was that nice. Been meaning to lift my drill press as well. Just actually have to do it.

Dust/wood chips and laminate floors might end up sketchy?

great job!

[Eric Roach]

Thanks.

The garage is on the other side of the wall the JWL1220 is on, the compressor is in there. I had the 15" drill press on top of the dust collector cabinet, but I moved it into the garage where it is better served (along with the table and chop saws).

I have a wire tapping the house's grounding rod, it comes through the wall next to the JWL1014. I do still have to run it through the collection system. I used that collector last year, I have to empty the bag at about 1/3 full.

The chips and dust seem OK so far on the laminate floor, but I sweep up any metal shavings immediately so I don't grind them in.

[striperman36]

Originally Posted by Saltys

Too clean

You need ground wires on that dust collection hose. Can't tell from the pics but it doesn't look like there's wires around the fittings...You are going to have a problem with that collection bag when it gets part full. Just from experience with that unit..

that unit generates some static too. I get shocked on just the single hose