Basement foundation wall paint?

[Karl F]

drylock or drylock extreme will do fine, clean it and prep it a bit first ...ask where you buy it for them to throw the 5 gallon pail in the mixer for you...stuff is thick... two coats.. i found if you tint the first coat a light gray, than put the second coat on untinted you get better coverage because you can see where ya been.. if you roll it make sure you back brush it, it must be worked into all the pinhioles in the concrete.
My bulkhead area was always the "damp spot".. insulated door inside, and the bilco up top.. I did the bulkead with two coats this fall, and it is dry as a bone now, even has reduced the condensation to almost nill on the underside of the bilco... Good Stuff.

[shark lobster]

drylock and sump pump ,, never had water famous last words ,,,, if you are gona spend the money to finish the space , spend a little more and add the dewater system its like insurance ,, im a contractor , been one for 20 yrs i would never finish a basement without one ,,, and hi bob t