Location: Reading Mass/Newburyport/merrimack river
Posts: 3,748
I cut off about 12-13' of 304 SS wire off a roll and form it around a pin.. be sure to over lap the long wire..
Now holding the wire to the pin... I bend back the tag end... this particular one isn't pretty... as I did not center the pliars when I bent the tag end... it's still funtional and turned out fine...
Thank you, Joe! I have some engineering ahead of me, but you have cut the learning curve by 99%! I hope to have some shop time late this afternoon.
“Americans have the right and advantage of being armed, unlike the people of other countries, whose leaders are afraid to trust them with arms.” – James Madison.
Hybrid Mode
