|
Clamp a board to the deck on your ban saw. Take the plug and get the place where you want the cut to be by adjusting the board.Mark the depth of the cut on the plug then slowly make the cut making sure you have your hook holes on the right side. Check your cut with a lip after trimming the end peices off.Repeat your cuts using the board as a fence to guide the plugs . You should end up with a prety consitant cut on all of the.Just make sure the end peices are the same size otherwise you'll have to redo the fence each time.If you've already cut the ends off from turning just use the fence the same way making sure to keep the plug as straight as you can . They should come out good.
|
Threaded Mode