Project Seacraft

[Vectorfisher]

Aint she PURTY Another leg up on the mountain





MH you can't think of the work or you would never get motivated, I tend to think of it as my blank canvas I can alter,modify the boat the way I want, not a cookie cutter factory boat, I will know how every part of this boat will be put together and too me when I am 15 miles offshore in this little bugger I will have no worries as to what is under my feet

[Vectorfisher]

Regarding the scupper issue, I left 3 1/2" from the sidewall of the boat to the edge of the existing floor I am going to pad my stringers 3/4" and lay my new floor to the edge of the existing channel this will give me a 3/4" channel around the perimeter of the floor. Also on my last boat Hydra Sports Vector my floor drains had ping pong balls which would allow water out and not in, although they were set in the floor (vertical) and the Sea Craft will be horizontal I don't see why they wouldnt work. Also my floor has tubes that drain into the bilge I am thinking of doing away with these ????? I will trailer so I don't forsee a problem but will try and adress the issue a bit

[TheSpecialist]

I stuck it, so I would'nt have to search for it. Besides I knew everyone would appreciate the work you are doing..

[MrHunters]

Originally Posted by Vectorfisher

Aint she PURTY Another leg up on the mountain





MH you can't think of the work or you would never get motivated, I tend to think of it as my blank canvas I can alter,modify the boat the way I want, not a cookie cutter factory boat, I will know how every part of this boat will be put together and too me when I am 15 miles offshore in this little bugger I will have no worries as to what is under my feet

fair enough... and if i had the skill i might say the same but until that happens


i can't wait to see your finished product

[thefishingfreak]

nice

[sportsman]

Freak this is what you need...A nice project boat!!