Shop Door Info??? - Striper Talk Striped Bass Fishing, Surfcasting, Boating

justplugit · 10-10-2006, 08:37 PM

Larry, ya don't remember the pics.

1x 6 or 8 pine[ vertical] held by a Z pattern with 2x6 or 8 pine.

i will try to post some more pics tommorrow.

Karl F · 10-10-2006, 09:03 PM

the door on the right in this pic?

BigFish · 10-11-2006, 06:25 AM

Yup! I know what it looks like and have seen the website....I need the particulars!

afterhours · 10-11-2006, 07:18 AM

did you try asking norm for the specs- i'm sure he built it.

BigFish · 10-11-2006, 09:51 AM

Ahhhhh....Norm and I are not close?

justplugit · 10-11-2006, 10:41 AM

With the Z frame you can lay your boards vertical or on an angle, like

Norm's. These doors are butted against 1x2 stops and give a good seal.

Just need a sweep on the bottomand they should be pretty air tight.

Hope it helps.

Karl F · 10-11-2006, 01:21 PM

Larry go to this old house dot com. and look around, they have a link where ya can email them a question...
if you want the herringbone on both sides with the frame not showing, that is doable too, ya make a door sammich... the link for the sliding (rolling) door hardware, will alow you to make your door panel work that way, if that is what you want..
I am sure you can figger it out..
Or.. call Slip.. he can do it

JPI.. nice door...