ball bit for poppers

[Finatic]

Originally Posted by go4broke44

do you have a fence or something set up so that bit doesn't wander? I would think the chance of it walking off the end of the lure, and into your hand would be high!

If you use the router bit with the bearing on the end, take the allen screw and bearing off. The stub will center the bit in the nose wire hole. Just gotta be careful no matter what tool is spinning.

[smac]

Jim, I use a spherical burr from Foredom. I go the coarse ball and let me tell this thing is no joke. I hold the popper perpendicular to the ball while it in the drill press. Very unforgiving. If your not careful, your popper face will be 2" deep.

Use a 1/2 drill bit first then use the burr to finsh.